PSA is compatible with all Peugeot cars from 1996 - 2017 onwards.ĭiagnostics is performed via 16 Pin OBD-II connector or via manufacturer-specific connector (only older cars, pre-2001). PSA is compatible with all Citroen cars from 1996 - 2017 onwards. Software requires at least Intel Celeron/Pentium i5 1.2 MHz, 4GB RAM, 10GB free HDD space and USB 1.1 port (USB 2.0 recommended) and Microsoft Windows 7 For DIAGBOX Online V8.31.
turn on fuel pump, lock/unlock wheel, lock/unlock doors, cut off fuel, etc.) LanguageĮnglish, German, French, Japanese, Russian, Spanish, Portuguese, Swedish, Turkish, Dutch, Polish, Italian, Hungary, Greek, Czech Specification of PC Actuator testĪctuator test activates particular actuator (e.g. Logging to file is also supported, which allows offline analysis. Values can be displayed in graph, 9 values at once, or full listing (all measured values). Program displays live Data like Engine Speed, Battery voltage, Oxygen Sensor, Coolant Temperature, etc. Auto-scan (complete car scan/test)ĭetects all ECUs (electronic control units) installed in car and reads all diagnostic fault codes.
This function clears all stored fault codes and other diagnostic information. Program supports report printing or copy to clipboard. Read fault codesĭisplays all stored and pending fault codes with complete description (e.g. PSA Interface Checker Install - program to change the firmware interface XS Evolution. part number, software/hardware version, manufacturer, etc. Read identificationĭisplays complete identification of control unit, e.g. This diagnostic interface contains K-Line multiplexor, CAN-BUS interfaces and SAE J1850 bus (both PWM and VPW). If anyone is able to help out here that would be so sweet, I have been going with this without succes for some weeks already and getting VERY tired of this.Currently Unavailable PSA XS A.1281 Z Interface Diagnostic Tool Function Do people here have experience of knowledge of broken units or bad interface cable toward the OBD? Could it be anything else? the profile I used is 20FFF000. I have done about everything I can think of and am almost ready to send it back to china for refund or repair. PP2000 will startup fine but also reports: no response from vehicle or the like. The options Global Test and Faults overview are always greyed out so not much to do here. Software starts up fine, sees the interface but there is just NO communication with my vehicle (306 ph3, 1999). I'm running XP emulated on virtualbox which runs bulky slow but OK.
Hi Guys, I'm new here but having the same problems with diagbox or better, the interface I guess.īought the lexia3 from .uk, firmware is 4.24 software is 6.09 and seems installed well, patched and all as described by citronel.
0 kommentar(er)
